EVA Deck Pad for kiteboard deck pad and SUP deck pad comes in two ways normally. One is full sheet for DIY, the other one is die cutting based on customized design. Eva Deck Pad,Surfboard Tail Pad,Kiteboard Deck Pad,Deck Grip Mat,Sup Board Deck Grip,Traction Deck Pad Huizhou City Melors Plastic Products Co., Limited , https://www.melorsmat.com
Pipe leaks or leaks may be installed screw nut is not tight. If the leakage is not serious, in the place of leakage or leakage coated with cement or asphalt mixing oil slurry. Temporary repair can be painted wet mud or soft soap. If leakage occurs at the connector, tighten the nut by hand. Leak serious must re-disassembly.
Overheating due to packing too much pressure is too tight, cooling water into the filler, or the shaft surface damage. Proper relaxation of packing can be taken to clear up the sealing tube blockage and other measures. Filler wear must be replaced by new ones. Soak it in the oil before installation, insert it in turn, and cut it off, which will reduce water leakage. After the last lap packing is installed, the gland should be installed tightly and the tightness should be adjusted during operation.
The pump does not absorb or not drain the main reason for the end of the valve stuck, part of the blockage of water filtration, water absorption is too high or water leakage may also be due to the wrong direction, impeller runner blockage and so on. After one by one inspection, respectively, to take the end of repair valve, remove the blockage, correct steering, cleaning impeller and other measures to deal with.
The full sheet deck pad can be in 230cm x 90cm or 90cm x 90cm size. Customers can cut the deck pad based on their board size, then simply peel and stick since the EVA deck grip we offered it with 3M adhesive. Besides, it can be also used in any other application for traction like boat flooring, yacht flooring and etc.
Submersible pump pumping water causes and treatment methods
Vibration pump may be uneven electric rotors, or coupling poor coupling, bearing wear and tear may also be rotating parts loose, rupture; may be due to the pipe bracket is not strong and so on. Can be taken to adjust, repair, reinforcement, replacement and other methods to deal with.
Based on the design file customers provide, we can make a mold to die cut the EVA, and you will see the designed pattern after we use the glue to connect different color EVA. AI file or PDF file would be what we need for quotation and production.