Nox Sensor 24V for DAF car, auto parts DAF Automobile 24V nitrogen and Oxygen Sensor is suitable for DAF tail gas treatment. Nitrogen and oxygen sensor is one of the key components of SCR post-treatment system. It is used to measure the concentration of nitrogen and oxygen in engine exhaust to meet the needs of closed-loop control of engine aftertreatment system and on-board OBD diagnostic system. It can be applied to gas engine or diesel engine. Its structure includes ceramic probe, cable and processing chip controller, which is connected with ECU through can communication. The effects of nitrogen and oxygen sensor damage are as follows: 1. If the nitrogen and oxygen sensor is damaged, the diesel control system is in an open-loop state, that is, the emission data cannot be accurately fed back, and the engine control unit cannot accurately adjust the emission. At this time, the vehicle's emission must exceed the standard. If it always exceeds the standard, the service life of tail gas emission treatment equipment will be shortened. 2. Because it is a key component for measuring the excessive exhaust of diesel vehicles. If it is damaged or works poorly, it will directly cause multiple fault lights of the engine to turn on. At the same time, there will be relevant fault storage records in the control unit. 3. The damage of nitrogen and oxygen sensor will lead to the disorder of diesel combustion control, resulting in weak acceleration, idle jitter, unable to start and so on,. Once a problem occurs, the nitrogen and oxygen sensor needs to be replaced in time. It is usually installed at the rear end of the catalyst in the exhaust pipe. Nox Sensor 24V For DAF Car,Daf Auto Parts 24V Nitrogen Oxygen Sensor,Daf Automobile 24V Nitrogen Oxygen Senso,Daf Engine Parts 24V Nitrogen Oxygen Sensor Ruian OKOOO Electronic Technology Co., LTD , https://www.okoosensor.com
GPS-series engineering drill rig is applied to large diameter cast-in-place piling with reinforced-concrete for high building, harbor, dam, bridge, basic engineering and also can drill large diameter hole of water well and engineering.
Features
This kind of rig is equipped a hydraulic device that can make can rotary and supporting plate to move away from the borehole.The mast is installed a guide way to the benefit of vertically of borehole and have a retraction system to move the kelly away from the center of rotary.It us equipped with a centrifugal mud pump system for pumping reverse circulation drilling to handle various conditions and formations and can be changed into direct circulation immediately to suit different needsTo life or lower mast is operated by hydraulic control quickly and reliablyMain and vice winches employ the mechanism of planetary-gear train, so the operation is simple and convenient.
Specifications
Unit
GPS-20
Drilling depth
m
80
Diameter of hole
m
2
Torque
KN.M
30
Speed
forward
r/min
8.5,15,27,43,65
reverse
8
Main winch capacity (single rope)
KN
30
Vice winch capacity (single rope)
KN
30
Mud pump
m3/h
180
Effective height
m
10
Drill pipe
mm
Â
Power
kw
37
Weight
T
10
Dimensions(LxWxH)
m
5.6x2.4x25.2
GPS20 Engineering Drilling Machine
Model NO.: GPS-20
Mining Object: Water Well
Trademark: RQ
Origin: China
GPS GPS-series engineering drill rig